TM  55-1520-240-23-5 6-3 REMOVE  NO.  2 THRU  NO.  6 FORWARD DRIVE  SHAFT (Continued) 6-3 NOTE Remove  any  of  shafts No.  2  thru  No. 6  in  same  way.   Typical  shaft shown here. REMOVE  END  NUTS Do  not  allow bolts to  turn.  If bolts turn, bolts  and  plates can  be  damaged. 1. Remove  nuts  (1) and  washers (2)  from  three bolts (3) at each  end  of shaft (4).  During  removal, hold  head  of  bolts with  wrench.  Do  not  remove bolts  at  this  time. Do  not  allow bolts to  turn.  If bolts turn, bolts  and  adapter  assembly  can  be damaged. NOTE If more  than  one  bolt is  removed  from each  adapter assembly,  assembly will have  to  be  balanced. 2. Remove  one  nut  (5),  special  washer  (6),  and bolt  (7) from  adapter  assembly  (8) at  each  end of shaft  (4).   During  removal,  hold  head  of  bolts with  wrench. 6-16