TM  55-1520-240-23-5 6-1 DRIVE  SYSTEM 6-1 The  drive  system  delivers  torque  from  the engines  to  the  rotary-wing  heads  and  blades. It  also  drives  the  ac  generators  and  pumps  for the  flight  control  and  utility  hydraulic  systems. The  drive  system  consists  of  five  transmissions, drive shafting  to  connect  the  transmissions, and  an  aft rotor shaft: 1. An  engine  transmission  is mounted  on  the  front of each  of  the  two  engines.  Torque  is transmitted from  the  engine  to  the  transmission  by a  splined quill  shaft. 2. Output torque  from  each  engine  transmission is  delivered  through  an  engine  drive  shaft  to the  combining  transmission.   The  combining transmission  combines  the  torque  from  both engines and transmits it to a  forward  transmission and  an  aft transmission  through  drive  shafting. 3. The  forward  transmission  is  splined  directly to the  rotary-wing  head  to  drive  the  forward  rotor blades. 4. The  aft  transmission  drives a  separate  vertical aft  rotor  shaft.   This shaft  is splined  to  the  aft rotary-wing  head  to  drive  the  aft rotor blades. 5. The  forward  drive  shafting  consists  of  seven aluminum  tubes  joined  by  flexible  adapter assemblies.  The  tubes are  referred  to  as  No.  1 thru  No.  7,  beginning  at  the  forward  end  of the shafting.  The  shafting  is supported  in  a  bearing at  each  adapter assembly by two  rubber  and metal  mounts. 6. The  aft  drive  shafting  consists of two  aluminum tubes  joined  by  a  flexible  adapter assembly.  The tubes  are  referred  to  as  No.  8  (forward) and  No. 9  (aft).  The  shafting  is  supported  in  a  bearing  at the  adapter assembly  by  two  rubber and  metal mounts. 6-2