TM  55-1520-240-23-4 5-9 INSTALL ROTARY-WING HEAD (Continued) 5-9 35. On  aft  hub  oil  tank  (21) only,  connect each  of three  droop  stop  springs (41) and  limiter springs (42) as  follows: a. Remove  nut (43),  washers  (44  and  45)  and bolt  (46). b. Check that  spring  (41),  limiter  spring  (42), special  washers  (47),  and  bearing  (48)  are assembled  as  shown. c. Install assembly (49)  between  lugs (50). d. Install bolt  (46),  nut (43),  and  cotter pin  (51). Install  washers  (44  and  45),  if  required,  to align  cotter  pin. 36. Check  that there  is  no  gap  between  flange  of bushing  (52) and  lower surface  of lower lug  (53). Have  qualified  inspector  verify  that bushings  (52)  are  installed.  Damage to  rotor  head/pitch-varying  housing will  result  bushings  are  left  out  of lower  lugs. INSTALL HEAD  WITHOUT   50 37. Install  one  sliding  bushing  (54) in  each  of  the three  lower  lugs  (53). INSTALL HEAD  WITH   50 38. Do  not  install  bushings  (54  and  54.1) in  each  of the  three  lower  lugs (53).   Bushings are  part  of rotor  head. INSPECT FOLLOW-ON MAINTENANCE: Attach  pitch  links  to  pitch  housings  (Task 5-99). Remove  pitch  lockpins (T22) if  blades were  attached (Task  5-96.2). Check vertical  pin  angles (Task 11-55). Install rotary-wing  blades if  blades  were  not attached (Task  5-84). Install  droop  stop  shrouds  on  aft  head,  if  required (Task  5-48.5). Inspect  centrifugal  droop  stop  springs and  balancing arms  (Task  5-50). END  OF  TASK 5-67