TM  55-1520-240-23-4 5-9 INSTALL  ROTARY-WING HEAD (Continued) 5-9 27. Install  tang  washer  (34)  on  nut (23). Do  not  file  tang  washer  to  make  it fit.   Filing  can  cause  tangs  to  break causing  loss  of  helicopter  and  loss of  life. 28. If  tang  washer  (34)  cannot  be  seated  in  any position,  repeat  steps  12  thru  27.   Increase torque  of  step  21  to  5750 foot-pounds  to  permit washer  to  be  seated. 29. If  tang  washer  (34)  cannot  be  seated  in  any position,  repeat  steps  18  thru  27,  increasing torque  to  6000  foot-pounds. Before  backing  off torque,  the  three reaction  hooks  must  be  reversed  so that  the  REMOVAL  side  faces  out, as  in  Task  5-8;  otherwise,  injury  to personnel  and  damage  to  equipment may  occur. 30. If  tang  washer  (34)  still  will  not  seat,  back  off nut  (23).   (Refer  to  Task  5-8.)  Repeat steps 18 thru  27,  torquing  nut to  5600 foot-pounds  and other  in-between  torques  as  needed  for  washer alignment. 31. Install  retaining  ring  (35)  in  groove  of nut (23). INSPECT 32. Install  packing  (36)  on  hub  oil  tank  (21). 33. Position  cover  (37)  on  hub  oil  tank (21). 34. Position  retainer  (38)  on  cover  (37).  Install  nine screws (39)  and  washers  (40).  Torque  screws  to 23 inch-pounds. 5-66