TM  55-1520-240-23-4 5-9 INSTALL ROTARY-WING HEAD (Continued) 5-9 7. Attach  two  rope  guidelines  (15)  to  rotary-wing head  (16).  Attach  hoist  (17)  to  lifting  device  (T30) (9). Head  weighs  700 pounds  (1,750 pounds with  blades  attached)  and can  injure  personnel  if  it  drops.  Head must  be  supported  by  hoist  and moved  carefully  to  prevent  injury. If  rotor  blades  are  installed,  use special  care  to  prevent  blades  from uncontrolled  swinging.   Station personnel  at  tiedown  lines  of  all blades.   Attempting  to  install  head without  securing  blades  can  result  in injury  to  personnel  and  damage  to helicopter. Lift  and  lower   head  slowly  and carefully  to prevent  damage to splines, thread,  and  surfaces. NOTE Grease  on  shaft  splines will be  pushed down  by  head  onto  seating  surfaces. INSTALL HEAD 8. Lift  head  (16).   Use  hoist  (17).   Clean  splines (18).  Use  cloth  (E120)  damp  with  solvent  (E162). Wipe  dry.  Use  clean  cloth  (E120).  Reach  under head  and  apply  thick  coat  of  grease  (E190) evenly  to  splines  (18).  Use  a  1 inch  brush.  Make sure  lower  surface  of  head  is  free  of  grease. Wear  gloves  (E186). 5-59