TM  55-1520-240-23-4 5-8.1 INSPECTION OF OIL LUBE  PORTS,  ROTOR  HEADS 5-8.1 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-323-4692 Materials: Lockwire  (E231) Cloth  (E120) Lubricating  Oil  (E254) Torque  Wrench Personnel  Required: Medium  Helicopter Repairer Inspector References: Task  1-55 TM  55-1520-240-23-1 General  Safety  Instructions: Oil  (E254) is  toxic.  It can  irritate  skin and  cause  burns.  Avoid  inhaling.  Use only with  adequate  ventilation.  Avoid contact  with  skin,  eyes,  or  clothing. In  case  of contact,  immediately  flush skin  or  eyes for at least 15 minutes. Get  medical  attention  for eyes. A  complete  or partial  restrictions  of lubricating  oil  to  the  horizontal  hinge pin  bearings  causes premature  wear and  results in  damage  to  the  bearings and  related  components. NOTE Six  oil  lube  ports  are  on  the  upper surface  of the  rotor hub.  These  ports are  located  on  both  the  forward  and aft  rotor  head. 1. Remove  lockwire  from  drain  plug  (6)  located below  each  horizontal  hinge  bearing  on  the  rotor head. 2. Remove  lockwire  from  one  of  the  three  filler plugs (4)  located  on  the  top  of  (main)  oil  tank mounted  on  the  top  of  the  rotor  head. 3. Remove  filler  plugs,  one  from each  tank. 4. Remove  plug  (6).   Observe  oil  flow.   If  oil  flow is  present,  one  oz.   minimum,  inspection  is complete  for  that  drain. 5. If  oil  flow  is not  observed,  probe  the  drain  hole with a  piece of safety wire  to  free  any obstruction. 6. Reinstall  drain  plug  (6)  and  torque  to  16 to  32 inch-pounds.  Lockwire  plug  (6)  to  bolt  (7).  Use lockwire  (E231). 5-53