TM  55-1520-240-23-4 5-8 REMOVE  ROTARY-WING HEAD (Continued) 5-8 14. Remove  torque  applicator  (T2)  (38). 14.1. Remove  reaction  adapter  (T28)  (32)  as follows: a. Loosen  three  handwheels  (36). b. Turn  clamps  (37)  outward. c. Lift reaction  adapter  (32)  from  head  (1). 14.2. Turn  socket (30)  and  nut (31)  counterclockwise by  hand. NOTE The  socket  can  be  turned  using  a suitable  tool  in  the  drive  hole  if  it cannot  be  turned  by hand. 15. Remove  socket (T29)  (30). 16. Remove  hub  retaining  nut (31)  and  washer  (40). LIFT HEAD 17. Prepare  rotor-head  lifting  device  (T30)  (41)  as follows: a. Remove  three  pins  (42). b. Turn  support  arms (43)  outward. c. Check  that  there  is  a  phenolic  pad  (43.1)  on the  shoulder  of each  support arm  (43)  and  on the  underside  of each  block  (43.2). d. Check  that the  distance  between  centers  of the threaded shaft (43.3)  of  each  support arm (43)  is  not  more  than  15.25 inches. e. Check  that  shoulder  and  threaded  shaft of  each  support  arm  (43)  is  an  integral assembly,  not welded  together. f. Check  that handle  (43.4)  is  welded  to  both surfaces  of  plate  (41). 5-50