TM  55-1520-240-23-4 5-8 REMOVE  ROTARY-WING HEAD (Continued) 5-8 NOTE Support  spring  load  before  removing bolt.   Sudden  release  of  spring  will cause  small  parts  to  fly  out  of  lugs. 3. On  aft  head  only,  disconnect  centrifugal  droop stop  springs  (10)  and  limiter  springs  (11)  as follows: a. Remove  cotter  pin  (12),  nut  (13),  and washers  (14  and  15). b. Support  spring  load  and  remove  bolt  (16). Remove  spring  (10),  two  washers  (17), bearing  (18),  and  inboard  limiter  spring  (11) from  lugs  (19). c. Assemble  bearing  (18),  two  washers  (17), spring  (10)  and  limiter  spring  (11).   Use  bolt (16),  washers  (14  and  15),  and  nut  (13). Do   not  lift  pitch  housing  when removing  aft  head  without  supporting balancing  arm.   Lifting  housing  will allow  arm  to  fall  against  other  parts when  springs  and  limiters  are  not connected.   Damage  to  equipment can  occur. 4. Lower  three  balancing  arms  (20)  as  follows: a. Hold  balancing  arm  (20)  in  place. b. Lift  housing  (21). c. Lower  arm  (20)  slowly  until  it  rests  on weather-protective  cover  (22). 5-46