TM  55-1520-240-23-4 5-7 REPAIR  ROTARY-WING HEADS (Continued) 5-7 f. Damage  to  horizontal pin  caps  (12)  shall  not exceed  0.010 inch  in  depth  by  2.5  inches  in length.  Refinish  (Task  2-343). g. Damage  to  pitch  shafts  (13)  shall  not exceed  0.005  inch  in  depth  by  2.5 inches in  length.  Rework  area  shall  not  exceed  1.0 square-inch.  Refinish  (Task  2-346). h. Damage  to  edges  of  three  pitch  arms (14)  shall  not  exceed  0.050  inch  in  depth. Refinish  (Task  2-346). i. Damage  to  edge  of  pitch  arm  (15)  where washer  contacts  arm  when  pitch  link  bolt is  installed  shall  not  exceed  0.060  inch  in depth.  Refinish  (Task  2-346). j. Damage  to  arm  faces  (16)  around  bolt hole  shall  not  exceed  0.040 inch  in  depth. Refinish  (Task  2-346). k. Damage  to  remaining  areas  (17)  of  pitch arm  (15)  shall  not  exceed  0.050  inch  in depth.   Rework  area  shall  not  exceed  1.2 square-inches.  Refinish  (Task  2-346). k.1. Damage  to  fillet  areas  (17.1)  where  pitch  arm blends  into  housing  shall  not  exceed  0.010 inch in  depth.  Repairs  more  than 0.005 inch deep  require  shotpeening.   Refinish  (Task 2-346). l. Damage  to  six  lugs  (18),  pockets  (19),  and center  housing  areas  (20)  shall  not  exceed 0.003  inch in  depth.  Rework  area  shall  not exceed  1.2  square-inches.   Refinish  (Task 2-346). m. Damage  to  tanks  (21)  shall  not  exceed 0.020  inch in  depth  by  2.5 inches in  length. Refinish  (Task  2-353). 5-42