TM  55-1520-240-23-4 5-6 INSPECT ROTARY-WING  HEADS (Continued) 5-6 Horizontal  hinge  pins  with  serial numbers  of  UW2407  and  prior  that  do not  have  a  suffix  "A"  vibro  engraved after  the  serial  number  and  with  total time  since  new  of  4800  flight hours or  more  must  be  replaced. NOTE Paint  removal  is  not  required  for rotary-wing  head  inspection.   Use flashlight  and  mirror  for  hidden  areas. Procedures  can  be  used  to  inspect forward  and  aft  rotary-wing  heads. 1. Check  all  surfaces  of  rotary-wing  head  (1), including  webs  (2),  lugs  (3),  and  holes  (4).  There shall  be  no  cracks,  burns,  or  pits.   If  a  crack  is suspected,  refer  to  TM  1-1520-253-23. NOTE Burns  and  pits  indicate  lightning strikes. 2. Check  rotary-wing  head  (1)  for  scores,  nicks,  or gouges  that  have  gone  through  paint.  Check  that damage  is  within  rework  limits  as  follows: a. Damage  to  top  hub  face  (5)  and  bottom  hub face  (6)  shall not  exceed  0.005 inch  in  depth by  2.5  inches  in  length  or  0.010 inch  in depth  by  1.0 inch  in  length. b. Damage  to  six  lugs  (7),  webs  (8),  and  side surfaces  (9)  shall  not  exceed  0.005  inch  in depth  by  0.625 inch  in  length. 5-32