TM  55-1520-240-23-4 5-4 PLACE  ROTARY-WING  HEAD IN  SERVICE (Continued) 5-4 NOTE Procedure  is  same  for  forward  and  aft rotor  heads. 1. Install  lifting  device  (T30)  (1)  on  rotor  head  (2) as  follows: a. Remove  three  pins  (3).   Turn  support  arms (4)  outward. b. Position  lifting  device  (1)  on  rotor  head  (2). c. Turn  three  arms  (4)  inward  under  top  flange (4.1)  of  head  (2).  Make  sure  each  arm points to  the  center  of  device  (1)  within  20º.   Make sure  each  arm  engages  flange  at  least  1/4 inch. d. Install  three  pins  (3). Do  not  use  wrench  to  tighten  nuts. Lifting  device  (T30)  can  be  damaged. e. Hand-tighten  three  nuts  (4.2). Rotor  head  is  heavy  and  can  injure personnel  if  it  drops.  Rotor  head  must be  supported  by  hoist  and  moved carefully  to  prevent  injury. 2. Attach  work  hoist  (5)  to  lifting  device  (T30)  (1). Lift  rotor  head  (2)  and  clean  splines  (6).   Use cloth  (E120)  damp  with  solvent  (E162).   Wear gloves  (E186). Move  rotor  head  slowly  and  carefully to  prevent  damage  caused  by  rotor head  hitting  handling  adapter. 3. Position  rotor  head  assembly  (2)  on  handling adapter  (T13)  (7).  Have  helper  guide  rotor  head. 4. Check  that  rotor  head  (2)  is  level. 5. Remove  lifting  device  (T30)  (1)  as  follows: a. Remove  three  pins  (3)  and  turn  arms  (4) outward. b. Remove  lifting  device  (T30)  (1). 5-22