TM  55-1520-240-23-4 5-3 REMOVE ROTARY-WING  HEAD FROM  SHIPPING  CONTAINER (Continued) 5-3 6. Remove  nine  screws (17) and  washers (18) from retainer (19).  Remove  retainer (19),  cover  (20), and  packing  (21). 7. Remove  six  nuts  (22) and  washers  (23) from three  clamp  angles  (24).  Remove  clamp  angles and  cushions (25). 8. Remove  nut  (26)  and  washer  (27)  from  clamp plate  (28).   Remove  clamp  plate  and  cushion (29). 9. Install  lifting  device  (T30) (30)  on  rotor head  (31) as  follows: a. Remove  three  pins (32).  Rotate  three  arms (33)  outward. b. Position  lifting  device  (30) on  head  (31). c. Turn  three  arms (33) inward  under top  flange (33.1)  of  head  (31).   Make  sure  each  arm points  to  the  center of  device  (30) within  20º. Make  sure  each  arm  engages flange  at least 1/4 inch. d. Install  three  pins  (32). Do  not  use  wrench  to  tighten  nuts. Lifting  device  (T30)  can  be  damaged. e. Hand-tighten  three  nuts (33.2). Head  is  heavy  and  can  injure personnel  if  it  drops.   Head  must be  supported  by  hoist  and  moved carefully to prevent injury to personnel. 10. Remove  head  (31) from  container (3).  Use  lifting device  (T30)  (30) and  mobile  hoist device  (34). 5-18