TM  55-1520-240-23-4 5-1 ROTARY-WING HEAD  AND  CONTROLS (Continued) 5-1 Three  pitch  links  are  installed  on  each  rotary-wing  head. Forward  and  aft  pitch  links  are  similar except  for  the angle  between  rod  ends.  Each  pitch  link  is adjustable to  change  the  pitch  of an  individual  blade.  Moving  the turnbuckle  toward  the  + mark makes  the  pitch  link longer and  increases  blade  pitch.   A  turn  in  the  -  direction shortens the  pitch  link and  decreases  blade  pitch. DRIVE COLLAR  AND  DRIVE  ARMS The  drive  collar transmits  torque  to  the  swashplate through  the  upper  and  lower  drive  arms.   The  drive arms  are  hinged  to  allow  the  swashplate  to  slide  up and  down  on  the  slider shaft.   The  splined  drive  collars mate  with  splines  on  the  transmission  rotor  shafts.   A flange  is located  on  the  drive  collar for installation  of  the weather-protective  cover.  Drive  collar  lugs  are  provided for connecting  the  upper drive  arm.  The  upper drive  arm is  connected  at  the  other  end  to  the  lower  drive  arm. Both  connections are  hinged.  A  ball  spherical  bearing on  the  lower drive  arm  is  connected  to  the  swashplate. This  arrangement allows  swashplate  to  tilt. WEATHER-PROTECTIVE  COVER The  weather-protective  cover is  bolted  to  the  drive  collar flange  and  turns  with  the  collar and  shaft.  The  cover provides  weather-protection  for  the  upper  controls. Flexible  boots protect  the  upper portion  of  the  pitch  links where  they  pass through  the  cover. 5-5