INSTALL AFT LANDING GEAR WHEEL AND TIRE ASSEMBLY (Continued)

TM 55-1520-240-23-3 3-12.1 INSTALL AFT LANDING GEAR WHEEL AND TIRE ASSEMBLY (Continued) 3-12.1 Dry cleaning solvent (E162) is flammable and gives off toxic fumes. It may irritate skin and cause burns. Use only in well-ventilated area, away from heat and open flame. In case of contact, immediately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. Never stand facing sidewall of tire being serviced. Stand facing tire tread. Oil (E254/E254.1) is toxic. It can irritate skin and cause burns. Avoid inhaling. Use only with adequate ventilation. Avoid contact with skin, eyes, or clothing. In case of contact, immediately flush skin or eyes for at least 15 minutes. Get medical attention for eyes. Dirt and mixed greases on bearings and bearing surfaces can cause damage to wheels. Clean bearings and surfaces before packing. NOTE Procedures are same for installing left or right wheel. Left wheel is shown here. 1. Clean bearings (1 and 2) and wheel surfaces thoroughly with dry cleaning solvent (E162). Wear gloves (E186). 2. Clean seals (3 and 4) with dry cloths (E120). 3. Pack bearings (1 and 2) with grease (E190). 4. Install bearing (1) in bearing cup (5). 5. Insert seal (3) over bearing (1). 6. Install bearing (2) in bearing cup (6). 7. Insert seal (4) over bearing (2). 3-45