INSTALL FORWARD LANDING GEAR WHEEL AND TIRE ASSEMBLY (Continued)

TM 55-1520-240-23-3 3-12 INSTALL FORWARD LANDING GEAR WHEEL AND TIRE ASSEMBLY (Continued) 3-12 7. Install wheel (7) on axle (8). Align brake disk (9) with keys (10) on wheel. Seat wheel on axle. 8. Check that outboard bearing (2) hangs over edge of journal (11) on axle (8). 9. If bearing (2) hangs over journal (11), go to step 11. Sealing compound (E350) is flammable and gives off toxic fumes. It can irritate skin and cause burns. Use only in well-ventilated area, away from heat and open flame. In case of contact, immediately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. 10. If bearing (2) does not hang over edge of journal (11) add spacer (12) as follows: a. Remove bearing (2), wheel (7), and sleeve bushing (13). b. Install spacer (12) between sleeve bushing (13) and axle housing (14). Do not use more than one spacer per wheel. c. Apply sealing compound (E350) to bore of sleeve (13). Install sleeve bushing on axle (8) while sealant is still wet. Wear gloves (E186). d. Install wheel (7) on axle (8). Align brake disk (9) with keys (10) on wheel. Seat wheel on axle. e. Install bearing (2) in bearing cup (5). 3-41