|
| |
Back
INSTALL EMERGENCY EXIT LIGHT PANEL AND PAN | Up
TM-55-1520-240-23-11 CH-47D Heilcopter Manual | Next
REMOVE INERTIA SWITCH |
TM 55-1520-240-23-11
17-10
INSTALL EMERGENCY EXIT LIGHT PANEL AND PAN
(Continued)
17-10
NOTE
Procedure is same to install any exit
light panel and pan. Panel and pan
above escape hatch are shown here.
1.
Route wires (1) through pan (2). Connect three
wires to back of panel (3) with screws (4) and
washers (5). Remove tags.
2.
Position pan (2) and panel (3) on structure (6).
Install three screws (7) and washers (8).
3.
Tighten clamp (9), if loosened.
4.
Install blankets (10) if removed (Task 2-210).
FOLLOW-ON MAINTENANCE:
Install emergency exit light (Task 17-8).
Stow work platform (Task 2-244) (for ramp panel).
Install left ramp extension (Task 2-244) (for ramp
panel).
Close ramp (Task 2-2) (for ramp panel).
END OF TASK
17-26
|
