REPLACE LOCKED-IN STUD (AVIM) (Continued)

TM 55-1520-240-23-1 1-15 REPLACE LOCKED-IN STUD (AVIM) (Continued) 1-15 NOTE Procedure is same to replace any locked-in stud. Typical stud shown here. For more information on locked-in studs, refer to TM 43-0104. If stud is broken off close to mounting surface, or if drill with speed below 700 rpm is not available, go to step 9. REMOVE STUD WITH REMOVAL TOOLS 1. Cover openings in component housing (1) in area of stud (2). Use barrier material (E80) and tape (E388). 2. Install removal tool (3) in drill or drill press. NO BREAK - WORK HARDER For Stud: Use Tool: MS51989-104 SM91-16 MS51989-105 SM101-18 MS51989-106 SM111-20 MS51989-107 SM121-22 MS51992B-504-13 B1575 SHF101-9SA(8)A SM101-18 ST-10045 SM101-18 1-22