5-5. REPAIR PARTS AND SUPPORT

TM 5-6635-386-12&P and ASL. See Appendix D. 5-5. REPAIR PARTS AND SUPPORT. Requisitions will be forwarded to and filled by DCSC. Routing identifier code (S9C) under milstrip procedures (AR 725-50) for non-NSN items see Appendix H, for NSN Items see Appendix 1. Requisitions should cite manufacturer’s part numbers in the absence of NSN’s. 5-6. PERSONNEL AND TRAINING a. All operational and support personnel will require training on the safe handling of nuclear devices (see Para 4-12). b. MOS Training: TRADOC will manage and coordinate the MOS training of operators. This training will be conducted by the 51 Committee (51 G) at Ft. Leonardwood, MO. 5-7. EQUIPMENT PUBLICATIONS a. Initially two sets of the Commercial Instruction Manuals, supplemented by a separate SOMARPI and TB 385-1 03 (Safety Procedures) were issued to support the soil tester. b. After initial issue of Tester, the manufacturers manuals, the SOMARPI and TB 385-103 were combined into this manual. 5-8. FACILITIES a. No special maintenance facilities are required for the tester. b. For storage facilities, see Section IV, Para 4- 17 and 4-18. 5-9. EQUIPMENT IMPROVEMENT RECOMMENDATION (EIR’S). EIR’s will be submitted in accordance with instructions contained in DA PAM 738- 750. 5-10. DESTRUCTION TO PREVENT ENEMY USE. When the tester cannot be evacuated the following will be done: a. Remove the circuit boards and display panel (loosen and remove the four screws located in the corners of the tester’s display panel, pull off panel, and cut or disconnect wiring). b. Destroy the display panel and circuit boards by crushing. c. Destroy worksheet and logs by crushing, tearing, and burying, or scattering over a sufficiently large area to make recovery improbable. d. Abandon the remainder of the tester. 5-11. PROCEDURE. In addition to operating and maintenance instructions, see Section IV, Safety Procedures, in this manual. 5-12. MANUFACTURER’S SAFETY DEFECTS. If any manufacturer’s safety defects occur, upon notification TACOM will advise users on action to be taken for correction and reporting. 5-13. MANUFACTURER’S FIELD CAMPAIGNS AND MODIFICATIONS. Modifications are not anticipated. If necessary, they will be applied by CPN after TACOM’s approval of the field campaign or modification plan. 5-14. BASIC ISSUE ITEM LIST. List of items which accompany the tester or are required for installation, operation. or operator maintenance (Appendix C). 5-15. PERSONNEL DOSIMETRY. See Section IV in this manual. 5-16. SHIPPING INSTRUCTIONS. Shipping Information for Tester, Density and Moisture, Nuclear Method, NSN 6635-01-030-6896. For additional information see paragraph 4-20. a. Consult with the unit Transportation Officer to insure that the tester is shipped in accordance with Department of Transportation Regulations (Title 49 CFR Parts 170-189) AR 385-11, TM 38-250, and the Nuclear Regulatory Commission Regulations (Title 10 CFR Part 71). For CONUS, a commercial shipper should be used to transport the tester. b. The following information is provided to assist in the preparation of shipping papers for the tester (Title 49 CFR Parts 172-173): 5-2