TM 5-6350-264-14&P-9 NAVELEX EE 181-AA-OMI-100/E121 DZ-204 T.O. 31S9-2FSS9-1-9 f.    To install new transformer, cut transformer  wires  to  proper  length  and install crimp terminals. Position transformer    on    inner    enclosure    and install mounting screws and lock washers.      Connect   wires   to   terminal board. g.    To  remove  capacitor,  tag  and  remove wires.      Loosen      screw   on   mounting bracket and remove capacitor. h.    To      install,   position   new   capacitor   in mounting  bracket  and  tighten  mounting screw.        Connect    wires    to    capacitor terminals. i.    To  remove  door  tamper  switch,  remove tamper switch support mounting screws. Push   switch   through   outer   enclosure. Tag wires and use a soldering iron of 50 watts     maximum to unsolder wires. Unscrew switch from switch support and remove switch. j.    To    install    new    door    tamper    switch, screw switch into switch support.  Solder wires    to    switch    terminals.        Position switch  and  support  on  outer  enclosure. Install  tamper  switch  support  mounting screws. k.    To remove pry-off tamper switch, remove   mounting   screws   from   tamper switch bracket.  Remove snap on button cap.    Remove  hex  nut  and  push  switch through  switch  bracket.    Tag  wires  and use     a     soldering     iron     of     50     watts maximum  to  unsolder  wires.    Remove tamper switch. l.    To   install   new   pry-off   tamper   switch, solder   wires   to   switch   terminals   and position  in  switch  bracket.    Install  hex nut  and  snap  on  button  cap.    Position switch    and    switch    bracket    on    inner enclosure  mounting  bracket  and  install mounting screws. m.    To    remove    power    transformer,    note length and connector location of transformer   wires.      Disconnect   wires. Remove  mounting  screws  and  washers and remove transformer. n.    To install new transformer, cut transformer  wires  to  proper  length  and install crimp terminals. Position transformer    on    inner    enclosure    and install  mounting  screws    and  washers. Connect transformer wires. o.    To   remove   power   switch,   slide   inner enclosure part way out of outer enclosure.  Remove  screws  from  switch bracket.   Lower   switch   bracket   to   gain access to power switch.  Tag wires and use     a     soldering     iron     of     50     watts maximum   to   unsolder   wires.   Remove knurled nut and remove power switch. p.    To   install,   position   new   power   switch bracket  and  install  knurled  nut.    Solder switch wires to switch terminals. Position switch bracket on inner enclosure  and  install  mounting  screws. Slide inner enclosure into outer enclosure. q.    To   remove   battery,   disconnect   battery wires from battery.   Remove  screw  and washer  from  battery  clamp  bracket  and remove battery. r.    To    install,    position    new    battery    and battery clamp bracket. Install screw and washer.        Connect    battery    wires    to battery. s.    To    remove    connector    P2/J2,    loosen collar on connector P2.  Turn metal tab 90 degrees and disconnect P2 from J2. Unscrew   collar   and   tag   wires.   Use   a soldering  iron  of  50  watts  maximum  to unsolder  wires  on  P2  and  J2.    Remove hex nut and remove connector.