Swath "Width

TM 5-3740-218-13&P 3 Set primary manifold pressure at 1200 psi. 4 Set both meters to same setting. WARNING Personnel handling solid or liquid pesticides shall use appropriate personal protective equipment consisting of respirators, coveralls, rubber gloves, goggles, etc., as required by type of pesticide used and in accordance with manufacturer's label directions. Avoid direct contact with pesticide. Observe all warnings on label. Handle pesticide in well- ventilated area. Failure to do so could result in personal injury. 5 Fill left and right hopper assemblies with pesticide. 6 Open left and right hopper assemblies for 1 minute and record weight of material in each container. (Be sure to subtract weight of container itself.) Repeat. 7 Change both meter settings to same setting. 8 Repeat steps 6 and 7 for each meter setting, then determine average flow rate (lb/min) for both hopper assemblies. 9 Repeat step 6 if one of the four weights for meter setting is significantly different from others. (b) Swath "Width. If new pesticide is being used, or flight altitude is to be over 50 ft, it is advisable to determine actual swath width. Perform the following: WARNING Personnel handling solid or liquid pesticides shall use appropriate personal protective equipment consisting of respirators, coveralls, rubber gloves, goggles, etc., as required by type of pesticide used and in accordance with manufacturer's label directions. Avoid direct contact with pesticide. Observe all warnings on label. Handle pesticide in well- ventilated area. Failure to do so could result in personal injury. 1 Fully assemble PDU for SD system operation and fill left and right hopper assemblies with desired pesticide or similar material with same density and particle size. 2-36