Section II. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES

TM 5-3740-214-14

Section II. OPERATOR PREVENTIVE MAINTENANCE

CHECKS AND SERVICES

GENERAL

The preventive maintenance checks and services (PMCS) are performed daily. This makes sure that defects are

discovered and corrected before they cause serious damage. The proper checks and services are listed in Table 2-1.

The preventive maintenance table is divided into three intervals of maintenance.

a. Before Operation (B). These checks should be limited to those required for consecutive application by an

assigned operator/crew. A statement as follows will be included in the heading of all PMCS tables to obtain increased

inspections when items are first assigned to an operator/crew or operation is resumed after a period of nonuse:

(1) You are the assigned operator and have not operated the item since the last weekly check.

(2) You are operating the item for the first time.

b. During Operation (D). These are checks and services needed to be performed while the engine is running.

Make sure to keep all Warnings and Cautions in mind while performing the checks and services.

c. After Operation (A). These are checks and services performed after shutting down the aerosol generator. They

make sure that the machine will be ready for operation the next time it is used.

If the aerosol generator fails to operate properly, turn to the troubleshooting sections. Use TM 38-750 to report any

mechanical defects.

PREVENTIVE MAINTENANCE CHECKS AND SERVICE

Table 2-1 lists all the preventive maintenance procedures that the operator must perform. Columns indicate the interval,

the items to be inspected, and procedures to be used by the operator. An equipment readiness column will indicate when

the aerosol generator is not ready for operation.

NOTE

Read the preventive maintenance checks and services through one time before performing the procedures.

2-3