|
| |
Back
M3 TAP COVERALLS. (CONT) | Up
TM-10-8415-210-13P Toxicological Agent Protective (TAP) Ensemble Manual | Next
M3/M4 TAP GLOVES |
TM 10-8415-210-13&P
5-15. M1 TAP FOOTWEAR COVERS
This task covers:
a.
Inspect M1 TAP Footwear Covers
b.
Repair Ml TAP Footwear Cover Material
INITIAL SETUP
Tools:
Maintenance Kit (Appendix B, Section III, Item 2)
Materials/Parts:
Ink Pad (Appendix F, Item 11)
Ink, Stencil (Appendix F, Item 12)
Chalk, White (Appendix F, Item 1)
Stencil Roller (Appendix F, Item 18)
Equipment Condition:
Footwear covers must be clean and decontaminated.
a.
Inspect. Inspect footwear covers in accordance with procedures outlined in Table 2-1. Use Equipment
Inspection and Maintenance Worksheet DA Form 2404 to record all defects found. The maximum number of patches
allowed on the inside or outside of the footwear covers is 4. If inspection reveals a condition that would render the
footwear covers unserviceable, turn-in IAW local SOP, otherwise, stencil footwear covers with next inspection due date.
NOTE
Soles of M1 TAP Footwear Covers shall not be patched.
b.
Repair Footwear Cover Material. No more than 4 patches may be applied to the inside or outside of the footwear
covers. Make repairs IAW paragraph 5-9.
5-27
|
