POWER ENTRY BOX 0 ASSEMBLY

POWER ENTRY BOX TM 9-2350-261-10 ASSEMBLY — M1068 ONLY WARNING When using external power, ensure proper grounding pro- cedures are followed. Failure to do so may result in personal injury and/or damage to the equipment. See TM 11-7010- 256-12&P for installing surface wire ground- ing system. serve safety WARNING HIGH VOLTAGE is used in the operation of this equip- m e nt DEATH ON CONTACT may result if personnel fail to ob- precautions. NEVER work on equipment unless at least one other person familiar with the operation and hazards of the equipment is nearby. That person should also be competent in giving first aid. When an operator helps a technician, that operator must be warned about dangerous areas. SHUT OFF POWER supply to equipment before beginning work. When working in- side equipment with power off, take special care to ground every capacitor likely to hold a dangerous potential. BE CAREFUL not to contact high-voltage connections when installing or operating this equipment. KEEP one hand away from the equipment to reduce the hazard of current flowing through life-sustaining organs of the body. The power entry box assembly, located at the upper rear roadside exterior comer of the carrier, along with cable W1 (external power input pigtail), and cable W2 (external A.C. power cable) provides the ability to receive or supply A.C. power. A workstation can be powered by using the on-board generator, external power source, or the carrier’s charging system. Change 3 1-36.1