General Instructions

TM 9-6140-200-14

NOTE

Never integrate a new battery into an old battery set. It is more

economical to replace the complete set of batteries and use the

removed and still serviceable batteries for other purposes.

Before making the electrical connection carefully clean the

connectors and connection cables using a suitable tool. In

particular, remove all remnants of grease.

The vehicle master on/off switch must be selected to "OFF" when

installing and removing any batteries.

Before installing sealed lead-acid batteries inspect the battery holders

and battery boxes for damage; repair as needed.

The battery's first date used must be shown by the 4-figure code on

the battery lid, e.g., 0683 for June 1983.

All sealed lead-acid batteries in one set should have the same put in

service date.

Check the battery at 6 month intervals with the aid of the lead-acid

battery tester (Item 22, Appx. B).

Do not use a lead acid battery charger to charge GEL batteries.

5-3 Battery care.

1. To insure that the battery is ready to operate and in a functional state. Do the

following actions:

a. Visually inspect the battery posts, battery filler caps and for external

damage, e.g. cracks in the battery case.

b. Clean batteries, as required, (see Chapter 3).

2. Replace the battery if posts are burnt or damaged in any other way.

3. Insure that "filler caps" are not covered by paint, grease or anything similar

substance.

5-2