Battery Installation

TM 9-6140-200-14

NOTE

When replacing individual batteries, make sure

replacement batteries are at least the same electrical

capacity as the old battery or as the battery pairs

remaining in the equipment. Do not use any battery

showing average difference of more than 0.025 specific

gravity or 0.5 volt between other batteries used in the

equipment. Charge batteries that do not meet the

minimum requirement.

(1) Check that new battery is fully charged and that battery capacity equals

other batteries used in the equipment (Refer to Note above).

(2) Install battery (ies) make sure they are clean and free of dirt, grease,

corrosion, etc..

NOTE

Large batteries require two-man carry

(3) Use carrying strap (Item 18, Appx. B) when handling small batteries.

For large batteries use carrying handles build into the battery case or cover.

(4) Install Battery

(a) Place battery in the battery tray or box carefully. Make sure battery is in

a level position in the tray or box.

(b) Make sure positive battery cable is in same location as old battery cable

when battery was removed.

(d) Tighten fasteners of the battery hold downs evenly a little at a time, first

one side and then the other to prevent cracking of the battery case until

the battery is securely seated. If one battery hold down is fixed type,

make sure battery is securely seated before any pressure is applied to

the moveable side. Do not over tighten hold downs.

3-21