Chapter 5. DIRECT SUPPORT MAINTENANCE

TM 5-6130-301-13&P

CHAPTER 5

DIRECT SUPPORT MAINTENANCE

Section I. TROUBLESHOOTING PROCEDURE

5-1. GENERAL

a. Scope. This section contains troubleshooting information for locating some of the troubles that may develop

in the battery charging distribution panel. Each malfunction or symptom of trouble given is followed by a list of

probable causes or tests, and corrective action to remedy the malfunction.

b. Method. This techical manual cannot cover all possible troubles and deficiencies that may occur under the

many conditions of operation. If a specific trouble test, or remedy is not covered, isolate the system in which the

trouble occurs, and then locate the defective component.

c. Maintenance Level. The tests and remedies in this section are governed by the direct support level of

maintenance.

Table 5-1. DIRECT SUPPORT TROUBLESHOOTING

MALFUNCTION

PROBABLE CAUSE

CORRECTIVE ACTION

Check wires for continuity with ohmmeter.

Repare or replace defective wires.

Replace wiring harness.

2. CABLE ASSEMBLIES FAULTY

Check wires for continuity with ohmmeter.

Repair or replace defective wires.

Replace defective connectors.

Section II. MAINTENANCE PROCEDURES

5-2. GENERAL. Disassembly and reassembly for most of the components of the Battery Charger Distribution

Panel generally involves no more than removal of attached hardware, and lifting or sliding the component from

the panel.

a. Disassembly. (Figure 5-1)

(1) Boat, circuit breaker. Remove two phillips head screws that secure circuit breaker boot (9) and

retaining plate and remove circuit breaker boot.

5-1