Chapter 4. ORGANIZATIONAL MAINTENANCE

TM5-6130-301-13&P

CHAPTER 4

ORGANIZATIONAL MAINTENANCE

Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE

A N D SUPPORT REPAIR

4-1. GENERAL. This section contains information on the repair parts, tools, and equipment issued to the

operator and organizational maintenance personnel for operating and maintaining the battery charging

Distribution Panel. Tools and equipment should not be used for purposes other than prescribed and when not in

use, should be properly stored.

4-2. REPAIR PARTS. Repair parts are listed in Appendix C of this manual.

4-3. AUTHORIZED COMMON TOOLS AND EQUIPMENT. Refer to the Modified Table of Organization and

Equipment (MTOE) applicable to your unit for Common Tools and Equipment.

4-4. SPECIAL TOOLS AND EQUIPMENT. Special Tools required to perform organizational maintenance on

the battery charging distribution panel are listed in (MAC) Maintenance Allocation Chart Section II. No other

special tools and equipment are required.

Section II. SERVICE UPON RECEIPT

4-5. INSPECTION.

a. Check the Battery Charger Distribution Panel data plate for positive identilcation.

b. Make a complete visual inspection of the exterior for evidence of damage which may have occured during

shipment.

c. Back out screws and lift panel exposing the components and check for loose wires or components.

4.6 INSTALLATION INSTRUCTIONS. The Battery Charger Distribution Panel installation size should be as

level as possible and should provide adequate ventilation.

4-7. INSTALLATION OF SEPARATELY PACKED COMPONENTS. There are no separately packed

components.

S e c t i o n III. ORGANIZATIONAL PREVENTIVE MAINTENANCE

C H E C K S AND SERVICES

4-8. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS). No PMCS is required. Refer to

paragraphs 2-2 and 2-3 for operator Preventive Maintenance Checks and Services.

4-1