Section II: OPERATION

TM 11-6625-823-15

nectors not in use, preventing pin

b. Removing Contents.

damage resulting from loose storage.

CAUTION

2-2. Checking Unpacked Equipment

The minimum cushioning thickness is

a. Inspect the equipment for damage in-

one-quarter of an inch; therefore, do

curred during shipment. If the equipment has

not cut deeper than one quarter of an

been damage report the damage on DD Form

inch.

6 (para 1-3).

(1) Cut and open the carton top.

b. Check to see that the equipment is com-

(2) Remove the top cushioning material

plete as listed on the packing slip. If a pack-

to reach the component. Adapter, Connectors

ing slip is not available, check the equipment

U-240/PSM-13, U-241/PSM-13, U-242/PSM-

against the basic issue items list (app B)

13, U-314/PSM-13, and U-315/PSM-13 are

and paragraph 1-7. Report all discrepancy=

packed in the cavities in the packing material.

in accordance with instructions given in TM

The U-242/PSM-13 is attached to the end

38-750. Shortage of a minor assembly or

of the U-241/PSM-13 to facilitate handling

part that does not affect proper functioning of

and prevent damage before packing. The U-

the equipment should not prevent use of the

410/PSM-13. and the U-847/PSM-13 are

equipment

packed inside the bag with the TS-1301/PSM-

c. If the equipment has been used or recon-

13.

ditioned, check to see whether it has been

changed by a modification work order. If the

(3) Remove the technical manual.

equipment has been modified, the MWO num-

(4) Remove the adapter connectors and

ber will appear on the front panel near the

the bag.

nomenclature plate. Check to see that any op-

(6) Save the packaging material for use

erational instruction changes resulting from

in reshipment

the modification have been entered in the equip-

ment manual.

NOTE

The bag accommodates only two

Current MWO's applicable to the

adapter connectors and the TS-1301/

equipment are listed in DA Pam 810-

PSM-13. The packaging form is a

good storage place for adapter con-

Section II

OPERATION

2-3. Test Set, Battary AN/PSM-13 Operating Control and Indicator

(fig. 2-2)

Control or indicator

Indicates remaining useful life of battery section as

Meter (3-division scale.)

follows:

Division

Condition of

battery section

of scale

Red (BAD) . . . . . . . . . .Less than 8 hours of renmining use-

ful life,

Yellow . . . . . . . . . . . . . . . Remaining useful life is uncertain

(Use battery only in fixed instalb

tion where the same type of bat-

tery is available.)

. . . . .More than 8 hours of remaining use-

Green (GOOD)

ful life.

Change 4

2-2