Explanation of Format of Table I and T e s t Equipment Requirements

TM 11-6625-2631-14

m a i n t e n a n c e allocation chart. This time is ex-

Each maintenance function required for an item is

specified by the symbol among those listed in d

pressed in man-hours and carried to one decimal

below which indicates the level responsible for the

place (tenths of hours).

required maintenance. Under this symbol is listed

f. Tools and Test Equipment. T h i s c o l u m n

a n appropriate work measurement time value

used to specify, by code, those tools and teat

determined as indicated in e b e l o w .

e q u i p m e n t r e q u i r e d t o p e r f o r m t h e designated

function.

d. Use of Symbols. The following symbols are

used to prescribe work function responsibility:

g. Remarks. Self-explanatory.

C--Operator / Crew

B-4. Explanation of Format of Table I and

O--Organization

T e s t Equipment Requirements

F--Direct Support

H--General support

The columns in table I follows:

I )-- Depot

a. Tools and Equipment. The numbers in this

column coincide with the numbers used in the tools

e. Work Measurement Time. The active repair

and equipment column of the maintenance

time required to perform the maintenance function

a l l o c a t i o n chart. The numbers indicate the ap-

is included directly below the symbol identifying

plicable tool for the maintenance function.

and category of maintenance. The skill levels used

b. Maintenance Category. The codes in this

to obtain the measurement times approximate those

c o l u m n indicate the maintenance category nor-

found in typical TOE units. Active repair time is

mally allocated the facility.

the average aggregate time required to restore an

c. Nomenclature. This column lists tools, test,

item (subassembly, assembly, component, module,

a n d maintenance equipment required to perform

end item or system ) to a serviceable condition

the maintenance functions.

under typical field operating conditions. This time

d. Federal Stock Number. This column lists the

includes preparation time, fault isolation /

Federal stock number of the specific tool or test

diagnostic time, and QA / QC time in addition to

equipment.

the time required to perform specific maintenance

e. Tool Number. Not used.

functions identified for the tasks authorized in the

B-2