Chapter 2: SERVICE UPON RECEIPT AND INSTALLATION

TM 11-6625-2631-14

CHAPTER 2

SERVICE UPON RECEIPT AND INSTALLATION

Section I. SERVICE UPON RECEIPT OF EQUIPMENT

2-1. Unpacking

c. Check to see whether the equipment has been

changed by a modification work order (MWO ). If

When packed for shipment, the test set, test

the equipment has been modified, the MWO

adapter, and technical manual are inclosed together

number will appear on the front panel. If modified,

in a corrugated cardboard box. No special

s e e t h a t a n y o p e r a t i o n a l i n s t r u c t i o n changes

procedures are required for unpacking.

resulting from the modification have been entered

2-2. Checking Unpacked Equipment

in the equipment manual. Check also to see

a. Inspect the test set for damage incurred

whether all MWO'S current at the time the

during shipment. If the test set has been damaged,

equipment is placed in use have been applied.

report the dam age on DD Form 6.

NOTE

b. Check to see that the test set is complete, as

Current MWO'S applicable to the

listed on the packing slip. If a packing slip is not

e q u i p m e n t are listed in DA Pam 310-7.

a v a i l a b l e , check the contents against table 1-2.

R e p o r t all discrepancies in accordance with TM

38-750.

Section II. INSTALLATION INSTRUCTIONS

without any battery connected to the test

2-3. General

set.

The TS-2530/UR is a hand-carried test equip-

Perform a preliminary operational check on the TS-

m e n t , packaged and shipped with Battery Test

2530 / UR as follows:

Adapter MX-8801 / PRC-90 as a complete unit

a. Obtain an unused, fresh battery BA-1568/ U

with all parts and components installed. Therefore,

f r o m Radio Set AN/ PRC-90.

no tools, materials, or installation instructions are

b. O b t a i n a n o p e r a b l e T S - 2 5 3 0 / U R a n d

required.

B a t t e r y Test Adapter MX-8801 / PRC-90.

2-4. Initial Checking and Adjustment of

NOTE

Equipment

If possible, retain a TS-2530 / UR, MX-

NOTE

8801 / PRC-90. and BA-1568 / U for the

Adjusting the TS-2530 / UR is limited to

AN / PRC-90 as a maintenance standard.

t h e meter zero adjustment. Use a non-

c. Perform the appropriate operating procedures

metallic screwdriver to adjust meter zero,

indicated in paragraph 3-4.

2-1