Tool and Test Equipment Requirements

TM 11-6140-203-14-4&P

specifies, by the listing of a "work time" figure in the

alphabetic code which leads to the remark in section IV,

appropriate subcolumn(s), the lowest level of

Remarks, which is pertinent to the item opposite the

maintenance authorized to perform the function listed in

particular code.

column 3. This figure represents the active time

required to perform that maintenance function at the

D-4.

Tool and Test Equipment Requirements

indicated category of maintenance. If the number or

(Sect. III)

complexity of the tasks within the listed maintenance

function vary at different maintenance

categories,

a. Tool or Test Equipment Reference Code. The

appropriate "work time" figures will be shown for each

numbers in this column coincide with the numbers used

category. The number of task-hours specified by the

in the tools and equipment column of the MAC. The

"work item" figure represents the average time required

numbers indicate the applicable tool or test equipment

to restore an item (assembly,

subassembly,

for the maintenance functions.

component, module, end item or

system) to a

b. Maintenance Category.

The codes in this

serviceable condition under typical

field operating

column indicate the maintenance category allocated the

conditions.

This time includes

preparation time,

tool or test equipment.

troubleshooting time, and quality

assurance/quality

c. Nomenclature.

This column lists the noun

control time in addition to the time required to perform

name and nomenclature of the tools and test equipment

the specific tasks identified for the maintenance

required to perform the maintenance functions.

functions authorized in the maintenance allocation chart.

d National/NATO Stock Number. This column

Subcolumns of column 4 are as follows:

lists the National/NATO stock number of the specific

C-Operator/Crew

tool or test equipment.

O-Organizational

e. Tool Number.

This column lists the

F-Direct Support

manufacturer's part number of the tool followed by the

H-General Support

Federal Supply Code for manufacturers (5-digit) in

D-Depot

parentheses.

e. Column 5, Tools and Equipment. Column 5

specifies by code, those common tool sets (not individual

D-5.

Remarks (Sect. IV)

tools) and special tools, test, and support equipment

required to perform the designated function

a. Reference Code.

This code refers to the

f Column 6, Remarks. Column 6 contains an

appropriate item in section II, column 6.

b. Remarks. This column provides the required

explanatory information necessary to clarify items

appearing in section II.

(Next printed page is D-3)

D-2