Section I. INTRODUCTION

TM 11-6130-412-40P

SECTION I

INTRODUCTION

Scope

(1) Source code. Source codes indicate the

manner of acquiring support items for maintenance,

repair, or overhaul of end items. Source codes are

This manual lists spares and repair parts; special tools;

entered in the first and second positions of the Uniform

special test, measurement, and diagnostic equipment

SMR Code format as follows:

(TMDE), and other special support equipment required

for performance of general support maintenance of the

Code

Definition

PP-2926D/U. It authorizes the requisitioning and issue

PA -I tem procured and stocked for anticipated or

of spares and repair parts as indicated by the source

known usage.

and maintenance codes.

General

-Item to be manufactured or fabricated at the

depot maintenance level.

This Repair Parts and Special Tools List is divided into

-Item is not procured or stocked because the

the following sections:

requirements for the item will result in the

replacement of the next higher assembly.

Section II. Repair Parts List. A list of

spares and repair parts authorized for use in the per-

-A support item that is not stocked. When

formance of maintenance. The list also includes parts

required, item will be procured through normal

which must be removed for replacement of the

supply channels.

authorized parts. Parts lists are composed of functional

groups in numeric sequence, with the parts in each

NOTE

group listed in figure and item number sequence.

Cannibalization or salvage may be used as a

source of supply for any items source coded

Section III. Special Tools List. Not

above except those coded XA and aircraft

applicable.

support items as restricted by AR 700-42.

c. Section IV. National Stock Number and Part

(2) Maintenance code. Maintenance codes

Number Index. A list, in National item identification

are assigned to indicate the levels of maintenance

number (NIIN) sequence, of all National stock numbers

authorized to USE and REPAIR support items. The

(NSN) appearing in the listings, followed by a list, in

maintenance codes are entered in the third and fourth

alphanumeric sequence, of all part numbers appearing

positions of the Uniform SMR Code format as follows:

in the listings.

National stock numbers and part

numbers are cross-referenced to each illustration figure

(a) The maintenance code entered in the

and item number appearance.

third position will indicate the lowest maintenance level

Explanation of Columns

authorized to remove, replace, and use the support

item. The maintenance code entered in the third

position will indicate one of the following levels of

Illustration. This column is divided as

maintenance:

follows:

Code

Application /Explanation

(1) Figure number. Indicates the figure

- Support item is removed, replaced, used at the

number of the illustration on which the item is shown.

organizational level.

(2) Item number. The number used to identify

- Support item is removed, replaced, used at the

item called out in the illustration.

general support level.

(b) The maintenance code entered in the

Source, Maintenance, and Recoverability

fourth position indicates whether the item is to be

(SMR) Codes.

repaired and identifies the lowest maintenance