Figure 4-2. Pin and Terminal Locations for Components Replaced at General Support Level (Sheet 2 of 4)

TM 11-6130-392-34

Figure 4-2. Pin and Terminal Locations for Components Replaced at General Support Level (Sheet 2 of 4)

sure S6 is actuated (in down and closed position)

0.04-0.08 inch coating of red staking compound

when measurements are made.

(SM-A-852314) on S1 and on T1 terminals 1 through

5. Go to section V.

(1) If continuity is good; go to step f.

(2) If continuity is not good; replace S1 (Sec-

(2) If continuity not good; replace S6 (Section

tion IV, para 4-21), apply a 0.04-0.08 inch coating of

red staking compound (SM-A-852314) on T1 termi-

f. Peel or pick away red staking compound on

nals 1 through 5. Go to section V.

CB1 (fig. 4-1 and 4-2). Check for continuity between

e. Peel or pick away red staking compound on S6

CB1-2 and CB1-1, and between CB1-4 and CB1-3.

(fig. 4-2 and FO-1). Check for continuity between

Make sure POWER switch is in ON position for this

S6A-C to S6A-NO and between S6B-C and S6B-NO

measurement.

(only two wires each side of interlock switch). Make

(1) If continuity is good; go to step g.

4-9