Switch

TM 11-6130-392-34

c. Insert the two wires of replacement cable

c. Installation procedures are essentially the reverse

assembly through the two holes in cable bushing.

of removal procedures (fig. 3-12).

d. Solder black wire to terminal 3 of SW1 and white

3-23. Switch

wire to E1 (fig. 3-12).

Removal and installation of any switch (2, fig. 2-1.1) is

3-26. Cable Bushing

as follows:

Removal and installation of cable bushing (8, fig. 2-1.1)

a. Note and record the switch terminals from which

is as follows:

the wiring is to be removed, then unsolder the wiring

from rear of switch.

Remove cable assembly (refer to para 3-25).

b. Unscrew the hex nut from rear of switch and

b. Using an arbor press, press cable bushing from

remove switch.

battery holder (11, fig. 2-1.1).

c. Installation procedures are essentially the reverse

c. Using an arbor press, press replacement cable

of removal procedures (fig. 3-12).

bushing into battery holder.

3-24. Banana Plugs

d. Install cable assembly (refer to para 3-25).

Removal and installation of either banana plug (4 and 5,

3-27. Threaded Insert

fig. 2-1.1) is as follows:

Removal and installation of threaded insert (10, fig.

a. Remove insulation sleeving (6, fig. 2-1.1).

2-1.1) is as follows:

b. Unscrew shell from plug and unsolder wire.

a. Turn cover (3, fig. 2-1.1) upside down and, using

an arbor press, press threaded insert from cover.

c. Slip new insulation sleeving over wire and

resolder wire to replacement plug.

b. Turn cover rightside up and, using an arbor

press, press replacement threaded insert into cover.

Screw shell onto plug.

3-28. Electrical Wire

e. Slide insulation sleeving over shell and shrink into

place with heat gun.

Removal and installation of electrical wire is as follows:

3-25.

Cable Assembly

a. Unsolder the defective wire from its connecting

terminals.

Removal and installation of cable assembly (7, fig.

2-1.1) is as follows:

b. Solder the replacement wire to its proper

terminals (fig. 3-12).

a. Unsolder white wire from E1 (fig. 3-12) and black

wire from terminal 3 of SW1 (fig. 3-12).

b. Pull the two wires of cable assembly from cable

bushing (8, fig. 2-1.1).

Change 1 3-23