Table 3-5. Performance Test Procedures

TM 11-6130-392-34

Table 3-5. Performance Test Procedures - Continued

Column 3

Column 2

Column 1

Reference, or Instruction

Acceptable Test Result

Test Procedure

Display reads . 0 when START TIME is

(10) S e t C H A R G E T I M E H O U R S

pressed, goes blank when START TIME

R E M A I N I N G to read 0 0 . 0 . Press

is released.

START TIME switch. Check display.

No current flow.

(11) Check panel meter.

Display is 9.9.

(12) Set CHARGE TIME HOURS RE-

Press

MAINING to read 09.9.

START TIME switch. Check display.

Display is .9.

(13) S e t C H A R G E T I M E H O U R S

R E M A I N I N G to read 0 0 . 9 . Press

START TIME switch. Check display.

Display is same, for each of the 8 different

(14) Repeat, as in (13), with settings at:

settings.

17.7

16.6

15.5

14.4

13.3

12.2

11.1

10,0

For each, check display.

Display did not change: reads 18.8.

(15) Set CHARGE TIME HOURS RE-

Press

MAINING to read 18.8.

START TIME switch. Remove power

cable from 115 VAC input source. Use

stopwatch; time 10 seconds and recon-

nect power cable. Check display.

Go to step (17) table 3-4.

All tests were passed . . . . . . . . . . . . . . . . .

(16) If performance tests are now com-

pleted, turn POWER switch to OFF.

Remove power cable from 115 VAC

source. Remove band from interlock

switch and remove clip leads from

REMOTE BATTERY jacks. Assem-

ble retainer and cover and set con-

trols per para 3-10e. Refer to figure

3-1.

POWER ON lamp lights.

(17 Connect power cable to 115 VAC. Set

POWER switch to ON. POWER ON

lamp should light.

(18) Set POWER OFF, disconnect power

cable, return battery charger to serv-

ice.

Section VI. MAINTENANCE OF BATTERY CHARGING TRAY ASSEMBLY

3-22. Connector

3-21. General

Removal and installation of any connector (1, fig. 2-1.1)

Repair of battery charging tray assembly at direct

is as follows:

support level is limited to replacement of items

listed in paragraph 3-3.

a. Note and record the connector terminals

from which the wiring is to be removed, then un-

WARNING

solder the wiring from rear of socket.

Disconnect cable assembly (7, fig. 2-1.1) from

b. Unscrew the hex nut from rear of defective

b a t t e r y charger b e f o r e p e r f o r m i n g a n y

connector and remove connector and terminal

m a i n t e n a n c e on the battery charging tray

washer.

assembly.

3-22 Change 1