APPLICATION

TB 1-1730-229-30-2

APPLICATION.

The two batteries are installed one in back of the other between the existing battery retainers. The

batteries are secured in place with self-tapping screws through the bottom flange at the front of the

battery and into the bottom of the battery compartment.

6. CORRECTION PROCEDURES.

Requisition two batteries, NSN 6140-01-457-4339.

Perform the following tasks:

(1) Disconnect and remove the 24-volt aircraft battery and associated tie-down hardware and

vents.

(2) Inspect installation area. Remove all signs of corrosion or rust. Touchup paint if required.

(3) Disassemble the battery disconnect and separate the 4 cables at the lugs.

(4) Install the first battery in the back of the battery compartment and tie down using a locally

fabricated clamp or self-tapping screws through the forward base plate on the battery.

(5) Install the second battery in the front of the battery compartment and tie down using a

locally fabricated clamp or self-tapping screws through the forward base plate on the

battery.

(6) Connect the lugs on the two positive cables to a dual conductor battery terminal clamp.

Repeat with the lugs on two negative (ground) cables.

(7) Connect the positive and negative terminal clamps and the 8 to 12-inch long battery

jumper cable to the two batteries as shown on Figure 1.