TM 1-1500-204-23-3 WARNING When  working  with  Alodine  1200 wear  gloves,  safety  goggles,  and protective clothing. Wear a NIOSH    approved    respirator.        If contact  occurs,  flush  with  water and get medical attention. CAUTION If  artist's  brush  has  metal  bristle retainer,   wrap   the   retainer   with two  layers  of  masking  tape  so  all of the retainer is covered. 8 Apply,  brush  Alodine  1200  coating (item 14, table 2-11) liberally to the metal surface using artist brush (item 15, table 2-11) or equivalent and allow to stand one (1) minute. 9 Apply   additional   coats   of   Alodine 1200  (item  14,  table  2-11)  at  one  (1)  minute  intervals until a light gold or tan color appears.  No more than five (5)   coats   are   required   for   coating   formation.      If   no coating occurs, reclean the surface and reapply Alodine 1200 (item 14, table 2-11). CAUTION Wash    the    brush    thoroughly    in water   immediately   after   use,   as the   Alodine   1200   will   attack   the bristles. 10 Rush the work area thoroughly with distilled  water  (item  11,  table  2-11)  followed  by  wiping with a clean piece of dean cheesecloth (item 16, table 2- 11). Table 2-11.  Expendable/Durable Supplies and Materials List (1) (2) (3) (4) (5) ITEM NATIONAL STOCK DESCRIPTION UNIT OF MEASURE NUMBER LEVEL NUMBER U/M 1 F 8040-01-129-2559 Adhesive PT P/N 82C18 2 F 8040-01-129-2558 Adhesive PT P/N 82C12 3 F 6810-00-184-4796 Acetone, Technical GL O-A-51 (81348) 4 F 8415-00-2668677 Gloves, Chemical Protective EA ZZ-G-381 (81348) 5 F 6515-00-753-4533 Tongue Depressor EA GG-D-226 (81348) 6 F 7920-00-514-2417 Brush, Acid Swabbing EA A-A-289 (58536) 7 F 9330-01-434-0772 Plastic Material, Interior and Exterior YD P/N 3629N (56221) 8 F 9330-01-434-7186 Plastic Material YD PIN 3603N (56221) Change 2  2-66