Serviceable Limits (Bladder-Type Cells)-cont

TM 1-1500-204-23-3 Table 2-6. Serviceable Limits (Bladder-Type Cells)-CONT Condition Limit Cell Exterior-continued Mislocated, blistered, split, or weather- Acceptable; missing tape to be replaced. checked tape. Blisters or looseness between labels or Acceptable. decals and body of cell. Weather checked or surface imperfections Acceptable if fabric is not damaged or broken. in outer ply or reinforcements. Blistered, loose or missing lacquer coating. Acceptable. Blisters between fitting flange and adjacent Maximum dimension of 1/4 inch; maximum of ply. one per lineal foot and two per fitting provided 1-inch bond is maintained. Delamination between plies. Maximum dimension of 1 inch; average of one per 5 square feet or area with maximum of five in any one 5 square foot area; minimum 5-inch solid bond between delamination. Damaged grommets in accessories. Acceptable provided serviceability is not affected. Blisters between outer ply laps. Maximum dimension of 1/4 inch; average one per 5 lineal feet of splice with a maximum of five in any one 5-foot length of splice. Blisters between plies (in cell panels). Maximum dimension of 1/4 inch; minimum 8- inch bond between blisters and no more than one per square foot of cell area. Channels in outer ply laps. Channels 1/4 inch wide running entire length of lap. Channels around entire edge of fitting flange. Maximum of 1/8 inch around entire fitting flange. Damage through any cord or fabric ply. Not acceptable. Fittings Rubber Face Fittings: Gouges, splits, or indentation on the Maximum depth of 1/16 inch by 1/16-inch sealing surface. maximum length. Weather checking of surfaces other than Acceptable. sealing surface. 2-17