|
| |
Back
Internal inspection | Up
TM-1-1500-204-23-2 General Aircraft Maintenance (Pneudraulics Maintenance and Practices) Volume 2 Manual | Next
Table 4-14. Hose Cutoff Factor, MIL-H-8788 or MIL-8790 Hose (in Inches) |
TM 1-1500-204-23-2
NOTE
Do not reuse high pressure hose which has
been in service. Also, never reinstall a fitting
on same area of hose in which it was first
installed. If an error is made in assembly, cut
away the old area, or use a new length of
hose, and reinstall the fitting.
(a) Using position notch on socket (step 1),
determine and mark that portion of hose end to be
confined within end fitting socket. This amount of hose
outer cover is to be stripped.
Figure 4-37. Nonself-Sealing, Aromatic-Resistant
Hose MIL-H-5593
Figure 4-38. Self-Sealing, Aromatic-Resistant
Hose, MIL-H-7061
Figure 4-39. Knife for Cutting Flexible Hose
Table 4-13. Inspection Ball Size Chart
Hose dash size
Ball size (inches)
-4
3/32
-5
9/64
-6
13/64
-8
9/32
-10
3/8
-12
1/2
-16
47/64
-20
61/64
NOTE
These are standard master ball sizes.
4-39
|
