|
| |
Back
Tube-Bending Machine, Hand-Operated. | Up
TM-1-1500-204-23-2 General Aircraft Maintenance (Pneudraulics Maintenance and Practices) Volume 2 Manual | Next
Hydraulic Fluid Dispenser, Aircraft, |
TM 1-1500-204-23-2
(2)
Periodic inspection. For frequency and scope of periodic inspection, consult operation and service
instructions manual for specific bending machine; however, the following shall be used as a general guide.
(a)
Visually Inspect tube-bending machine for cracks, loose bolts and nuts, mounts for security, and
defective or damaged parts.
(b)
Lubricate tube-bending machine as required.
f.
Master Gauge Unit. This unit consists of a pressure gauge, a manual control valve, and length of flexible
hose with connecting fittings. A typical unit is shown in figure 3-5
(1)
Replace flexible hose when it becomes frayed, cut, or deteriorated.
(2)
Replace gauge or control valve when found to be defective.
Figure 3-5. Typical Master Gauge Unit
3-8
|
