SECTION I. INTRODUCTION

TM 5-3740-210-20P

Code

Explanation

SECTION I.

Repair parts which are stocked in or supplied from

INTRODUCTION

the GSA/DSA, or Army supply system and

authorized for use at indicated maintenance

1. Scope

categories

Repair parts which are not procured or stocked, but

This manual lists repair parts, special tools, test and

are to be manufactured in indicated maintenance

support equipment required for the performance of

levels

organizational maintenance of the sprayer.

Assemblies which are not procured or stocked as

such, but are made up of two or more units.

2. General

Such component units carry individual stock

numbers and descriptions are procured andstocked

separately and can be assembled to form the

This Repair Parts and Special Tools List is divided into

required assembly at indicated maintenance

the following sections:

categories.

Parts and assemblies which are not procured or

a. Prescribed Load Allowance (PLA)-section II. A

stocked and the mortality of which normally is

composite listing of the repair parts, special tools, test

below that of the end item or component. The

and support equipment having quantitative allowances

failure of such part or assembly should result in

for initial stockage at the organizational level.

retirement of the end item from the supply

system.

b. Repair Parts--Section III. A list of repair parts

Repair parts which are not procured or stocked. The

requirement for such items will be filled by use of

authorized for the performance of maintenance at the

the next higher assembly or component.

organizational level in figure and item number

Repair parts which are not stocked. The indicated

sequence.

maintenance category requiring such repair parts

will attempt to obtain same through cannibalization.

c. Special Tools, Test and Support Equipment -

Where such repair parts are not obtainable

Section IV. A list of special tools, test and support

through cannibalization, requirements will be

equipment authorized for the performance of

requisitioned, with accompanying justification

maintenance at the organizational level.

through normal supply channels.

(Not Applicable).

Major assemblies that are procured with PEMA funds

for initial issue only as exchange assemblies of

d. Federal Stock Number and Reference Number

DSU and GSU level. These assemblies will not

be stocked above DS and GS level or returned to

Index-Section V. A list of Federal Stock Numbers in

depot supply level.

ascending numerical sequence followed by a list of

(2) Maintenance code indicates the lowest category

reference numbers in ascending alpha-numeric

of maintenance authorized to install the listed item. The

sequence, cross-referenced to the illustration figure

maintenance level code is:

number and item number.

Code

Explanation

NOTE

Organizational Maintenance

Items not illustrated are cross-referenced to

group number.

(3) Recoverability

code

indicates

whether

3. Explanation of Columns

unserviceable items should be returned for recovery or

The following provides an explanation of columns in the

salvage. Items not coded are expendable.

tabular lists in sections II, III, and IV:

Recoverability codes are:

a. Source, Maintenance, and Recoverability Codes

Code

Explanation

(SMR).

Applied to repair parts (assemblies and components)

which are considered economically repairable at

NOTE

direct and general support maintenance levels.

Common hardware items known to be readily

When the maintenance capability to repair these

available in Army Supply channels are assigned

items does not exist, they are normally disposed of at

Maintenance codes only.

Source codes,

Recoverability codes, and Maintenance Allowances

the

are not assigned this category.

(1) Source code indicates the selection status

and source for the listed item. Source codes are:

Ill