Preparation for Use When     you     use     GP     bombs     the     following preparations  must  be  carried  out.  As  you  read  this section, refer to figures 13-2 through 13-4. BREAKOUT.—Breakout   is   the   term   used   to define  the  physical  removal  of  ammunition  from  the magazine. Weapons are broken out, by direction of the ordnance  handling  officer  (OHO),  in  accordance  with the load plan. When ordnance breakout is directed by the   OHO,   the   breakout   crew   records   the   type,   lot number, and quantity of ordnance broken out. Then, the crew passes this information back to ordnance control so that an accurate account and location of weapons and related material on board can be kept up to date. UNPACKING.—You  must  depalletize  the  bomb body  and  place  it  on  the  appropriate  bomb  skid  or assembly   stand.   Prior   to   depalletizing,   ensure   that gloves, steel toe shoes, and face shields are worn. When depalletizing  a  bomb  body,  you  need  to  remove  the 13-2 BOMB ASSEMBLY TOOL/EQUIPMENT REQUIREMENTS Spanner wrenches (spreader type) 2 each Apex tip holders (with setscrew) 3/8" drive 4 each Apex tip for 500 lb bomb conical fins 2 each Apex tip for 1000 lb bomb conical fins 2 each Apex tip for 500 lb retarding fin 2 each Apex tip for nose setscrew 3/16" 2 each Apex tip for butt plate removal 2 each 1/2" drive speed handle 2 each 3/8" drive speed handle 3 each Needle nose pliers 2 each 6" Straight slot screwdriver, 1/4" blade 2 each 8" Straight slot screwdriver, 3/8" blade 2 each Phillips screwdriver 8" No. 2 2 each Band cutters 1 each Full face shields 2 each Heavy duty work gloves 2 pair Wire cutters (diagonal wire cutting) 2 each Wooden dowel 2 each Non sparking wire brush 2 each Local manufactured bar for rolling bombs 1 each Allen wrench sets 2 each 1/8" Allen wrench 2 each Explosion proof flashlight 3 each Sway brace/lug gauge GMU-74/E 2 each Nut driver 3/8" for fuze restraining clip (nut drivers are enclosed with case of clips) 2 each Closure ring wrench P/N 1379AS503 3/8" drive ratchet 2 each Table 13-1.—Bomb Assembly Tool Requirements