Figure 3-24.-Installing retaining bands

Figure 3-23.-Automatic parachute ripcord release assembly. the inside faces up. Attach and crimp one end of both short container spring opening bands to the container eyes with hooks facing down (fig. 3-24). You will find that different parachutes use different lengths of arming cables. There are also several different time-delay cartridges that can be used at this time. Before you attempt to install the arming cable or the cartridge, check the NAVAIR 13-1-6.2 to ensure you are using the right ones. Inspect, arm, and assemble the automatic parachute ripcord release in accordance with the NAVAIR 13-1-6.2. Record the time delay, lot number, DODIC, part number, type of cartridge, and the expiration date on the Parachute Configuration, Inspection, and History Card. Now you are ready to install the ripcord release into the ripcord release pocket, close the slide fastener, and secure the protector flap. Insert the power cable through the buttonhole in the top end of the container. Route the end of the arming cable housing through the housing port located in the right side of the release pocket and through the buttonhole located on the right side of the container (fig. 3-25). Close the fastener flaps of the release pocket. Figure 3-24.-Installing retaining bands. Figure 3-25.—Inserting power cable. 3-11