POLICY FOR SAFETY PROGRAM

Navy Ammunition Logistic Code listed in the Navy Ammunition Stock Microfiche, TWO10- AA-ORD-010/NA 11-1-116A (NOTAL). DODICs are also specified in the four technical manuals mentioned in the details for block 11. Block 4—Nomenclature or Type of Device. Enter the name/type device. Block 5—Lot No. Enter the lot number of the device. Block 6—Serial No. Enter the serial number of the device. For devices not serialized, enter Block 7—Purpose or Location. Enter the purpose or the location of the device. Block 8—Installing Activity/Date. Enter the short title of the activity and the month and year that the device was installed; for example, VA34/JUL90. Block 9—Container Open Date. Enter the month and year the container was opened; for example, JUL 90. When the container open date is not required for AEPS devices, “NA” will be entered. Block 10—Date of Manufacture. Enter the date, month, and year of manufacture; for example, JUL 90. For CADS enter manufacture date, and for AEPS enter propellant manufacture date. Block 11—Expiration Date. Enter the computed month and year; for example, JUL 90. Installed service-life expiration dates for explosive devices are computed from the date of manufacture, the date the hermetically sealed container is opened, and the date the device is installed. The method used in computing the expiration date of explosive devices and the number of months/years a specific device may remain in service is contained in NA 11- 85-1-1.2(NOTAL), NA 11-100-1.1(NOTAL), NA 11-100-1.2(NOTAL), and NA 11-100-1.3(NOTAL). When installed explosive safety devices have extensions granted, the expiration date will be updated by drawing a line through the old expiration date and placing the new expiration date above it. The authority granting the extension, for example, message originator and date time group (DTG or IRAC number and manual), will be logged in the Remarks Column (block 12). Block 12—Remarks. Make applicable remarks. This block is limited in size; use the Miscellaneous/History page if additional space is required. Block 13—Removal Date. Enter the month and year the device was removed; for example, JUL 90. POLICY FOR SAFETY PROGRAM Learning Objective: Recognize the importance of training personnel to fully comply with safety precautions and directives. While no attempt has been made in this training manual to cover all the areas of safety responsibility pertaining to the AME rating, enough has been presented to stress to the AME1 and AMEC the importance of safety. Senior AMEs must continually strive to improve the safety program. The AME must interpret and apply safety directives and precautions established by the Department of the Navy, type commander, local command, and the precautions required for each job. Safety directives and precautions must be followed to the letter. This will save lives, prevent injuries, and prevent damage to equipment. Should an occasion arise in which doubt exists about the application of a particular directive or precaution, the measure to be taken is that which will achieve maximum safety. A shipboard operation requires more attention to safety than a shore-based operation. Although, in most instances, the hazards and the precautions are the same whether the work is done afloat or ashore. 1-13 “NA.”