SIMPLE CALIPERS

otherwise damaged. Do not use the hook as a stop. Slow down as you reach the end. SIMPLE CALIPERS Simple calipers are used in conjunction with a scale or rule to determine the thickness or the diameter of a surface, or the distance between surfaces. The calipers you will most commonly use are shown in figure 2-9. Outside calipers for measuring outside diameters are bow-legged; those used for inside diameters have straight legs with the feet turned outward. Calipers are adjusted by pulling or pushing the legs to open or close them. Fine adjustment is made by tapping one leg lightly on a hard surface to close them, or by turning them upside down and tapping on the joint end to open them. Spring-joint calipers have the legs joined by a strong spring hinge and linked together by a screw and adjusting nut. For measuring chamfered cavities (grooves) or for use over flanges, transfer calipers are available. They are equipped with a small auxiliary leaf attached to one of the legs by a screw (fig. 2-9). The measurement is made as with ordinary calipers; then the leaf is locked to the leg. The legs may then be opened or closed as needed to clear the obstruction, then brought back and locked to the leaf again, thus restoring them to the original setting. A different type of caliper is the hermaphrodite, sometimes called odd-leg caliper. This caliper has one straight leg ending in a sharp point, sometimes removable, and one bow leg. The hermaphrodite caliper is used chiefly for locating the center of a shaft, or for locating a shoulder. USING CALIPERS A caliper is usually used in one of two ways. Either the caliper is set to the dimension of the work and the dimension transferred to a scale, or the caliper is set on a scale and the work machined until it checks with the dimension set up on the caliper. To adjust a caliper to a scale dimension, hold one leg of the caliper firmly against one end of the scale and adjust the other leg to the desired dimension. To adjust a caliper to the work, open the legs wider than the work and then bring them down to the work. Figure 2-10.-Using an outside caliper. CAUTION Never place a caliper on work that is revolving in a machine. Measuring the Diameter of Round Stock or the Thickness of Flat Stock To measure the diameter of round stock or the thickness of flat stock, adjust the outside caliper so that you feel a slight drag as you pass it over the stock. (See fig. 2-10.) After the proper “feel” has been attained, measure the setting of the caliper with a rule. In reading the measurement, sight over the leg of the caliper after making sure the caliper is set squarely with the face of the rule. Measuring the Distance Between Two Surfaces To measure the distance between two surfaces with an inside caliper, first set the caliper to the approximate distance being measured. Hold the caliper with one leg in contact with one of the surfaces being measured. (See fig. 2-11.) Then, as you increase the setting of the caliper, move the other leg from left to right. Feel for the slight drag indicating the proper setting of the caliper. Then, remove the caliper and measure the setting with a rule. 2-5