Engine Preservation (cont)

TM 9-2815-202-34 3-4. ENGINE FROM/TO CONTAINER - 10909159/09231080* (Cont) (f) (9) (h) (i) (j) (k) (1) (m) (n) (o) (P) (q) Reinstall rocker arm covers (48). Install two bolts (45), two flat washers (46), and two rubber isolators (47). Torque to 15-20 Ib-ft (20-27 N-m), Repeat steps (a), (d), (e), (f), and (g) for right rocker arm cover. Install hose (43) and clamp (42) on rocker arm cover breather inlets (44). Tighten clamp. For model 7083-7396, position air outlet tube (50) between turbocharger and air inlet. Slide hoses (51 ) and clamps (49) onto turbocharger and air inlet. Tighten clamps. For model 7083-7399, install air inlet housing (54), three bolts (55 and 56), six Iockwashers (57) and six flat washers (58). Torque bolts (55 and 56) to 16-20 Ib-ft (22-27 N-m). Slide hose (59) onto turbocharger and tighten clamps (53). Connect line (52) from turbocharger waste gate valve (61 ) to air inlet housing (54). Install oil filler cap or tape opening. Tape air inlet and exhaust openings closed. Fill the crankcase with oil to a point approximately 15 inches below the top of the oil gage rod tube, (used oil can be used for this purpose). Manually turn engine over at least one complete revolution. Remove oil drain plug and drain oil. Reinstall oil drain plug. 3-22