REG-FILT. SHUT-OFF 50-6518 OPERATING & MAINTENANCE INSTRUCTIONS

REG-FILT. SHUT-OFF

50-6518

OPERATING

MAINTENANCE INSTRUCTIONS

Supply air inlet is a 1/2" NPT on the side of filter head (1).

The shut-off valve (7) on the side of filter (1) is filtered supply line

pressure air.

Regulated filtered air is supplied thru the regulator (4) mounted

on the side of filter (1). The regulator (4) is used to control the air

pressure. Turn the adjustment rod on the regulator (4) out to

decrease air pressure and in to increase air pressure. When

desired air pressure is maintained, tighten locknut on the

adjustment rod. Regulated filtered air is supplied to the shut-off

valves (7) mounted on the side of the regulator (4). Regulated

filtered air pressure is indicated on a pressure gauge (6)

mounted on the regulator head.

Gauge reads in pounds per square inch (PSI) from 0-160 PSI.

The bowl of the filter (1) should be drained daily or whenever

water accumulates in the bottom of the bowl. To drain, open the

drain valve on the bottom of the valve. The filter should be

disassembled and cleaned periodically.

DISASSEMBLY OF FILTER FOR CLEANING AND

MAINTENANCE.

CAUTION

Turn off the air supply before loosening or

removing any parts from this unit.

FILTER DISASSEMBLY

Remove bowl and bowl guard by pressing lever and turning ring

and remove parts by sliding off. Unscrew baffle to remove filter

element. Clean element by tapping on hard surface and blowing

off with air blow gun. To assemble follow above instructions in

reverse.

REGULATOR MAINTENANCE

Occasionally unscrew plug and clean internal parts. Gauges (6),

valves (7), mounting bracket (5) and fittings may be removed for

cleaning or replacing by unscrewing from filter (1) or regulator (4).