SPRAY OUTFIT ASSEMBLY INSTRUCTIONS

The paint spray gun cup attaches to the threads on the head of the Spray Gun.

The fluid tube should point away from the gun with the cup removed. The cup is held in

place by a yoke which is activated by turning the lock ring to attach or release the cup.

An air line is attached to the threaded fitting on the handle of the gun. The other end of

the hose is attached to the shut-off valve on the separator.

DESCRIPTION

The Model 76 is a heavy-duty production spray gun

which will spray a complete range of materials, such as

lacquers to heavy synthetics, with ease, using either a

siphon cup or pressure feed.

OPERATION

There are two basic controls on the 76 spray gun. The

fan control (18) regulates air going to the holes of the air

cap. The fluid needle adjustment screw (8) controls

needle travel and fluid flow.

Mix and prepare material according to instructions for

siphon feed.

1. Attach air hose to gun at air inlet (10)

2. Attach cup or pressure feed to gun at material

inlet

3. Adjust air pressure to desired amount at the Air

Regulator

4. Adjust fluid volume by turning the fluid control

screw (8) to the left or right.

5. Adjust to proper pattern by turning the fan control

screw (18) to left or right.

The most efficient atomization air pressure is the lowest

possible air pressure that will give the desired results.

A spraying distance of 6 to 12 inches from gun to work

surface is recommended. The gun should be held

perpendicular to the surface being coated.

The stroke should be started before the trigger is pulled

and the trigger released before the end of each stroke.