Section I. INTRODUCTION

DIRECT SUPPORT

AND

GENERAL

SUPPORT

MAINTENANCE

R E P A I R PARTS A N D SPECIAL TOOLS LIST

( I N C L U D I N G D E P O T M A I N T E N A N C E REPAIR PARTS

AND SPECIAL TOOLS)

Section I. INTRODUCTION

1. Scope.

This manual lists repair parts, special tools

and

test and support equipment required for the

per-

formance of direct support, general support,

and

depot maintenance of the AGT 9 and AGT 9A

test

stand.

2 . General.

T h i s R e p a i r P a r t s a n d S p e c i a l T o o lS List is

divided into the following sections:

a. Repair Parts List-Section II. A list of repair

p a r t s authorized at the direct support, general

support, and depot levels for the performance of

m a i n t e n a n c e . The list also includes parts which

must be removed for the replacement of the

authorized parts. Parts lists are composed of

functional groups in ascending numerical sequence,

with parts in each group listed in figure and item

number sequence.

b . F e d e r a l S t o c k N u m b e r a n d Reference

N u m b e r I n d e x - S e c t i o n I I I . A list, in ascending

numerical sequence, of all Federal stock numbers

a p p e a r i n g in the listings, followed by a list, in

alphameric sequence, of all reference numbers are

cross referenced to each illustration figure and item

number appearance.

3. Explanation of Columns.

The following provides an explanation of

columns found in the tabular listings.

a. Source, Maintenance, and Recoverability

C o d e s (SMR).

(1) Source Code. Indicates the source for the

listed item. Source Codes are:

(2) Maintenance Code. Indicates the lowest

category of maintenance authorized to install the

r e p a i r part and/or use the special tool or test

e q u i p m e n t for each application. Capabilities of

higher maintenance categories are considered equal

or better. Maintenance codes are: