Click here to make tpub.com your Home Page

Page Title: Figure 2-22. Transferring liquid from both compartments .
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
Figure 2-21. Transfer operation liquid fill, storage compartment only
Up
TM-5-3655-210-12 Conversion Storage and Charging Unit Carbon Dioxide: Gasoline Engine or Electric Motor Driven Manual
Next
Figure 2-23. Transfer of liquid carbon dioxide from the storage pressure vessel .

TM 5-3655-210-12
h. Set the unit for automatic operation, and engage
empty, or sufficient liquid has been pumped into the.
receiver unit.
only the refrigeration clutch.
With all the liquid
f.  Disengage the clutch to the transfer pump.
contained in the storage pressure vessel, set the valves
Close the liquid fill and vapor equalizing line valves on
in the normal position as indicated in figure 2-13.
the receiver unit.
2-11. Transfer of Liquid Carbon Dioxide from Both
g. Close valves 3, 6, and 7. Open valves 26 and
Pressure Vessels Simultaneously.
28 to bleed off carbon dioxide trapped in the transfer
hoses, and then disconnect the transfer hoses.
h. Set the valves for the normal position as
a. Set the driving unit for manual operation, and
indicated in Figure 2-13. Set the controls for automatic
disengage all clutches.
b. Set the valves as indicated in figure 2-22 and
operation, and engage the refrigeration clutch only if
liquid carbon dioxide is remaining in the pressure
start the driving unit.  Refer to table 2-1 for valve
vessels.
identification.
c.  Connect the liquid and vapor transfer hoses
2-12.
Transfer Of Liquid Carbon Dioxide From The
(stored in the storage compartment) to the liquid fill line
Storage Pressure Vessel (Liquid In The
and vapor equalizing line at the rear of the trailer, and to
Storage Pressure Vessel Only)
the receiver unit.
d. Close valves 1, 3, 10, 26, and 28 (fig. 2-22).
a. Set the driving unit for manual operation, and
Open the liquid fill and vapor equalizing line valves on
disengage all clutches.
b. Set the valves as indicated in Figure 2-23 and
the receiver unit.
e. Open valves 3, 6, 7, and 10.  When liquid
start the driving unit.  Refer to Table 2-1 for valve
appears at valve 10, close the valve and engage the
identification.
c.  Connect the liquid and vapor transfer hoses
transfer pump clutch. Continue to pump liquid into the
receiver unit until the pressure vessels are
(stored in the storage compartment) to the liquid fill
TS 024500
Figure 2-22 .
Transferring liquid from both compartments .
2-21

Privacy Statement - Press Release - Copyright Information. - Contact Us